Auto Code Search
While “auto code search” is recommended by RCA as the easiest way to program your remote, it may also take the longest.
Turn On the Device to Program Power up the device to program into your remote. No need to connect it to your system; the component needs only power at this stage.
Press and Hold the Device Key on the Remote Press the key corresponding to the device you’re programming. In some cases, such as a combined VCR/DVD key, you may need to select which device you’re programming by using a number key while holding down the device key. VCRs use the number 2 for example, while DVD players use the number 3. Check your remote’s instructions for these number key options. Release both keys once you’ve entered the correct number.
Prepare for Auto Code Search Press and hold the device key you’re programming then press and hold the On/Off key until the key’s light comes on and stays on; then release both keys.
Start the Auto Code Search Point the remote at the device you’re programming. Press the Play button on the remote to send a batch of 10 codes to the device. Wait five seconds and watch for the device to turn off. If it does not, press Play again and wait another five seconds. Continue this sequence until the device turns off.
Identify the Correct Code Press the Reverse key on the remote to cycle through the last batch of 10 codes. Wait at least two seconds after pressing Reverse to see if the device turns on. If not, press reverse again until it does. When the device turns on, press the Stop key. The device is now programmed in the universal remote memory.
Direct Code Entry
When you know the manufacturer’s code for the device you’re programming, entering it directly can be much quicker than using the auto code search.
Select the Device to Program With the device to be programmed turned on, press and hold the corresponding device button on the remote. With your other hand, enter the five-digit code for your device. The On/Off key goes out after entering the first number but will light up when you’ve entered a valid code.
Check for Proper Operation Point the remote at the device and press the On/Off key. The device turns off if you’ve entered the correct code for the device. If it doesn’t turn off, use the next code in the manufacturer’s list of codes for that device type, and repeat Step 1.
Brand Code Search
Some popular brands are stored in the remote’s memory. Limiting your search to one of these brands may be your quickest programming option.
Look Up the Brand Code for Your Device From the universal remote’s instructions, locate and note the brand code for your device. This is the number you will enter into the remote.
Prepare the Remote for the Brand Code With the device being programmed turned on, press and hold the corresponding device key, then press and hold the On/Off key. The On/Off key light will go out, but hold the buttons until it turns on again. Release both keys at this point.
Enter the Brand Code Use the number pad to enter the brand code into the remote.
Cycle Through Brand Codes Point the remote at the device and press the On/Off key, waiting at least two seconds. If the device shuts off, you’ve found the correct code. If not, press the On/Off key again and wait at least two seconds. Repeat this until the device shuts off. Then press Stop to set the code, and you’re ready to use the device. Writer Bio
